Arr2
Command line: arr2
Description: draw area table
TopoLT toolbar: 
Menu: TopoLT » Area » Area table
In the case of circles and polylines
with arcs it is made approximation with segments accordingly to areas precision.
Approximating arcs it is eliminated or added the areas of the circle segments.
Dimension of the segment is calculated so that the area of circle segment to be
equal to areas corresponding to precision that was established at Configuration - Units – “Decimals number of
area”. By example for decimals number equal to 2 the area of circle segment
will be 0.01, for 1 decimal it will be 0.1 and for 0 decimal it will be 1.0. By
reducing the decimals number of area the number of segments will be smaller
(low precision), by increasing the number of segments will be larger (high
precision).
If in a vertex of polyline it is not
found a point then it will be asked for the confirmation to insert graphical
point.
The table can be drawn as an
analytical area calculation table, a coordinate list, or a polyline side-length
table. For the coordinate list, you can choose to display either 2D or 3D
coordinates. When 3D coordinates are selected, the Z coordinate of each point
is retrieved from the attributes of the point located at the corresponding
polyline vertex.
Coordinates
order
Coordinates order it is provided to
table type established at Configuration - Table
– “Table type”. The titles of axis can be changed in the same tab. The
name of measurement unit can be changed at Configuration
- Units – “Coordinates measurement units”.
Table dimensions
Table dimensions depend on points
data, font and text height established at Configuration
- Table – “Tables from drawing”.