FixPct
Command
line: fixpct
Description:
fix point
and entities passing near point
TopoLT
toolbar: 
Menu:
Command applies to one point and does the followings:
·
fixes point to the decimals’ number of the coordinates
(accordingly to configuration section Units);
·
breaks and drags into the point entities placed at a smaller
distance than the minimum accepted distance between two points (accordingly to
configuration section Points). When a line passes near point then
line will be broken in two parts. When a polyline passes near the point then a
new Vertex will be inserted in the polyline. When an arc passes near the point
then this will be fixed by a slight modify of both radius and center's position
so that the arc to pass through point and to keep arc’s margins in the same
values of coordinates.