Ipct
Command
line: ipct
Description:
insert
graphical point
TopoLT
toolbar: 
Menu:
Point’s coordinates can be introduced numerical or graphical
by pointing in drawing. Points’ coordinates will be fixed at decimals so that
to assure decimals’ number allocated to configure section Units.
The new introduced code (description) is relative to the
code of the introduced graphical point when you configured section Points.
When you graphically introduce a point, entities (lines,
polylines, arcs, blocks) that are passing near point at a smaller distance than
the minimum distance between points (accordingly to the configuration of
section Points)
will be either fixed into point or cut and dragged into the point. When a line
passes near the point then the line will be broken in two parts. When a
polyline passes near the point then a new Vertex will be inserted in the
polyline. When an arc passes near the point then this will be fixed by a slight
modify of both radius and center's position so that the arc to pass through
point and to keep arc’s margins in the same values of coordinates.
In case you work with elevations, if when you introduce a
points it’s coordinates contain Z elevation different from 0.000 then the
elevation of introduced point will have this elevation. If Z elevation is 0.000
then you will be notified to introduce elevation manually.
When checking points overwriting (accordingly to the
configuration of section Points) if a point is inserted over another
one already existing in drawing you will be asked to confirm point replacing,
unreplacing (point won’t be inserted) or overwriting (the new point will be
written over the old one without replacing it.