Draws quickly longitudinal and cross profiles.

If the primness option of the selected profiles defined in ProfCfg - General Tab – Draw profiles is not used then the profiles must be selected in order. If this option is used then the profile will be arranged by the program according to the criteria described at ProfCfg -General Tab – Draw profiles.

The profiles will be drawn directly in the drawing according to the saved options in the command ProfCfg.

The insertion point of the profiles must be chosen down and from this point up the profiles will be drawn according to their alignment.

The vertical distance between the profiles is defined at ProfCfg - Longitudinal Profiles Tab - Longitudinal Profiles Arrangements Options and ProfCfg - Cross Profiles Tab - Cross Profiles Arrangements Options. In the case of the longitudinal profiles split into pieces the horizontal distance between subprofiles is applied between the profiles that are defined in the same section.